Roofing & Ventilation
Timber & Sheet Material
Plastering & Drylining
Ladders & Scaffolding
Cements & Aggregates
Paint & Stains
Windows & Doors
Lawn & Garden
Outdoor Power Equipment
Fencing & Decking
Vacuums & Floor Care
Humidifiers & Dehumidifiers
Outdoor & Landscape Lighting
Cooling & Heating
Nails, Screws & Fixings
Coving is a decorative feature that conceals the edge between a wall and ceiling, to give a room a finished look. Coving comes in various sizes and designs to suit any type of décor. For a professional result with any coving, follow our simple step-by-step guide.
Protect your flooring by laying a plastic sheet or tarpaulin. You should also protect your hands for this task with protective gloves.
Hold a 6 inch piece of coving into position and mark the top and bottom with a pencil.
Hammer a panel pin into the wall at the bottom mark.
Stretch a chalk line between this panel pin and the bottom of the coving you are butting against or at the other end of the wall. Pull the chalk line out from the wall and let it snap back, this will leave a mark across the wall.
Hammer in panel pins every 18 inches along your bottom marked line. Offer your cut section of coving into place to ensure a proper fit.
Apply coving adhesive to the back of the coving along the edges. It is not necessary to apply adhesive to the centre as it will not come in contact with any surface.
Lift your adhesive covered coving on to the top of your line of panel pins and push firmly. Hammer panel pins into the ceiling at the top edge of the coving to hold the coving in place as the adhesive sets.
Remove the excess adhesive from the edge of the coving with a palette knife and a damp cloth.
Apply a thick bead of flexible filler to the top and bottom edges of the coving.
Using a damp sponge, smooth the filler to leave a clean edge.
After the filler is dry, sand until completely smooth.